Grips and Mirrors
JD wrote in to ask a good question about the bar and grip setup on my R5:
Well, sorta.
The 698XLs I ordered wound up being closed-ended, despite the description on the site I bought them from, and they didn't carry the open-ended ones. That's OK, though, as I discovered that I really wanted the 699 Superbike grips... same company, same material, just a cooler grip pattern. And supposedly open-ended. So I exchanged for those.
And, of course, they arrive close-ended. So at this point I simply took an Xacto to them and trimmed myself a hole. Both grips, as I had mirrors on both sides.
The grips are excellent. They really dampen the vibration of the motor. However, the bar-end mirrors, while looking rather trick, no matter how much tightening and adjusting, they just never stayed put. The one thing I could count on was a good view of the ground behind me or my armpit - not good when you actually need to check your background for a quick lane change.
So, I decided to remove the bar-ends, replace the original black plastic caps that came with the cafe bars in their stead, and mount the original dental mirror. While it's only on one side, I really like the look of it. Plus, due to the lower speeds of the bike while cruising, I'm usually in the right hand lane anyways. I may keep an eye out for a NOS mirror for the other side too... might not look bad with both on there...
For more info, see posts titled Mirror Swap (5/31/04) and Hmmmm... (7/13/04), below.
I noticed that you have bar end mirrors, do you also have stock grips? If so how did you install the mirror on the throttle grip - just cut a hole?Here's the deal. I replaced the stock bars for lower, somewhat uncomfortable, but much better looking cafe bars. In order to get the clutch lever off the stock bar, I had to cut the stock grip. I tried not to, but the sucker wouldn't budge. Once the one was cut, well, I went ahead and replaced them both with open-ended ProGrip 698XL Superbike grips.
Well, sorta.
The 698XLs I ordered wound up being closed-ended, despite the description on the site I bought them from, and they didn't carry the open-ended ones. That's OK, though, as I discovered that I really wanted the 699 Superbike grips... same company, same material, just a cooler grip pattern. And supposedly open-ended. So I exchanged for those.
And, of course, they arrive close-ended. So at this point I simply took an Xacto to them and trimmed myself a hole. Both grips, as I had mirrors on both sides.
The grips are excellent. They really dampen the vibration of the motor. However, the bar-end mirrors, while looking rather trick, no matter how much tightening and adjusting, they just never stayed put. The one thing I could count on was a good view of the ground behind me or my armpit - not good when you actually need to check your background for a quick lane change.
So, I decided to remove the bar-ends, replace the original black plastic caps that came with the cafe bars in their stead, and mount the original dental mirror. While it's only on one side, I really like the look of it. Plus, due to the lower speeds of the bike while cruising, I'm usually in the right hand lane anyways. I may keep an eye out for a NOS mirror for the other side too... might not look bad with both on there...
For more info, see posts titled Mirror Swap (5/31/04) and Hmmmm... (7/13/04), below.
Labels: Cool Product, My R5, Reader Mail, Technical
This entry was posted
on Friday, September 30, 2005 at 7:01 PM.
You can skip to the end and leave a response.
Subscribe via RSS, or
» Post a Comment